Built-In Loadbox + Speaker Simulation XLR Out for Silent Stages Or Direct Recording, No Speaker Cab Needed.
FEATURES:
- Four 6.5″ Special Design Hi Def. Speakers
- 50W of Pure Power
- Tube Configuration & Weight
- Preamp: Seven 12AX7 tubes
- Power Amp: Two 6L6GC tubes
- Weight: Only 21 lbs (10 kg)
Built-In Loadbox/Power Soak for Silent Stages And Direct recording
Play your all-tube amp silently—NO speaker cab needed, and no risk of damage.
The built-in speaker mute switch safely redirects the amp’s power to an internal reactive load, protecting your gear.
This lets you connect the SABRE Signature 50 amp directly to your sound card audio interface or PA system using the balanced XLR output.
Get the full tone of your amp without the volume — perfect for silent stages or home studio recording, with no need for a mic’d speaker cabinet. a full amp direct recording (just like mic’d recording).
Clean Channel:
- Crystal-clear sound with deep lows, punchy mids, and rich bell highs.
- Controls: Gain, Bass, Mid, Treble, Master, and Tone
- FAT Switch: Boosts low-end for thicker, fuller clean tones.
Overdrive Channel:
Two distinct modes for any style:
Low Gain Mode: Warm, dynamic overdrive with a rich, full-bodied tone—perfect for blues, rock, and classic Marshall-style crunch.
High Gain Mode: Based on Elan Memran’s Metalhead Mods,– This mode delivers massive sustain, rich harmonics, and infinite gain while keeping every note articulate.
Built-in noise gate:
The high gain section has a controllable Elan`s famous noise reduction system -removes hum and hiss cased by Elan`s high gain mod makes your sound and tone extra tight.
Independent Master Volumes:
Each channel has its own master volume. this feature making it easy to balance clean and overdrive tones.
lowering your volume does not effect your sound and tone quality and it make it easy for you to play at bedroom level without sacrificing your tone and sustain
Built for Versatility:
Footswitch & Toggle Controls:
Switch channels and modes effortlessly—use the footswitch or front-panel toggles for:
- Clean / Overdrive
- Low / High Gain
- FAT Mode ( toggle switch only )
- Noise Reduction On/Off ( toggle switch and sensitivity control only )
Active Tube FX Loop:
Send/Return tube driven loop for pure warm signal integration with your pedals—preserves your tone’s integrity.
Speaker Outputs:
Compatible with 4, 8, and 16-ohm cabinets for any rig.
Flat Speaker Simulation Circuit:
Use the direct balanced output for silent practice or recording—no speaker cabinet required. ( as long as the speaker on/off is at OFF position!